FLT3 PAN? (in NRPN)
In the NRPN list there are 3 Filter Pan parameter. What is FLT3 Pan? Panning of the output of the Noise Filter?
Don't see it on the VCA page. Is it available somewhere else?
Where is it positioned? Not visible on Voice architecture either.
On the VCA page, there is 2 times FLTPAN. Not clear which one is FLT1 and FLT2. Will raise a bug in Firmware.
Shouldn't the FLTxPAN be also visible on each FLT page?
I think on the VCA page, it's just listed from top to bottom (1 to 2). So yeah, I hear you on that.
I think FLT3 pan is panning the noise filter.
I developed the MIDI Designer Pro 2 layout for the RT Accelerator and just looked through the whole layout. I found 3 'pan' settings. Two for filters (Filter 1 and Filter 2) and one for the Noise filter.
If you haven't checked out the layout, and have an iPad, you should look at it, or at least review the youtube video I have on it.
It has everything listed that you can access via NRPN.
Well, I was expecting a confirmation from Jörg on that and from the way you are answering, I think we are on the same level of uncertainty 😉
We both "think" that FLT3 pan is the Noise filter panning (and most probably it is) and we both know that FLT3 pan is not available directly on the Accelerator but only via NRPN. So, this is a change that should be done to the firmware.
I don't have an iPad but I'm well aware of your great work.
I developed a panel handling all parameters and it is the reason I raised the question. When OK (at the moment I didn't succeed to get it working in bidirectional mode, only from panel to synth and I have not done any librarian stuff or multi part handling due to other priorities), I will share it (standalone PC/Mac, VST, AU). The look and feel is also not final.