Forum

How to configure, l...
 
Notifications
Clear all

[Solved] How to configure, level and route external signals into Acclerator´s FX Bus ?


ulap
 ulap
Active Member
Joined: 2 years ago
Posts: 5
Topic starter  

Unfortunately, I do not understand how to use the inputs for a proper signal routing into the Acc FX bus. btw, as good as the Acclerator is, the so called "manual"is a desaster .  This option is just mentioned but not described in the manual.

so here is my use case:
I have an old analog synth plugged into the inputs of the Accelerator and -sure thing- the MIDI out of the Accelerator feeds the MIDI input of the external Synth.  The expander receives the Midi Signals from teh Accelerator, plays notes , as expected.

Now I d like to generate a simple Init Preset just for the synth-expander, by setting the Accelerator Midi Local Off, and routing the Analog Signal from the expander into the Accelerator Inputs ,  and then using the Main Outs of the Accelerator for further Audio processing with the Audio Interface.

My question is: How and where can I calibrate the input levels and mix the incoming audio signal  via the Acc´s FX busses ? I would have expeted something under the System Menue but cannot finde "input-Level" and/ or  "FX Bus routing"

I am happy to receive any guidance 🙂

 

thanks

This topic was modified 2 years ago by ulap

Quote
ulap
 ulap
Active Member
Joined: 2 years ago
Posts: 5
Topic starter  

ok, solved.too simple 😉


ReplyQuote
oliverdann
Active Member
Joined: 3 months ago
Posts: 5
 

My question is: How and where can I calibrate the input levels and mix the incoming audio signal  via the Acc´s FX busses ? I would have expeted something under the System Menue but cannot finde "input-Level" and/ or  "FX Bus routing"


ReplyQuote