Link faders and knobs in Logic Pro X Environment to Accelerator
Is it possible to link fader and knob in Logic Pro X Environment with NRPN, like this man did with sysex https://www.youtube.com/watch?v=OJdIYAp5q2M&frags=pl%2Cwn
I never checked that but it should be possible. Instead of a Controller choose SYSEX as the fader message. Then you can create a multi byte message with NRPNs and Data Entry values for the fader. The fader or knob then controls the Accelerator. The knob itself can be automated.
Thank you for your quick answer.
That work very well with data 0 to 127. Picture (vc01 waveform).
However when data are between -255 to 255 (14bit), that is more complicate.
I don't know if you can use 14 bit range in Logic Environment. Picture flt1 CutOff
Of course I could use 4 knobs and changing Control 6 with value 62 to 65. However I hope there is a better workaround.