Forum

SPECTRALIS I:Encoder 1 don't work when I push it.  

  RSS

toh
 toh
Active Member
Joined:3 months  ago
Posts: 8
08/06/2018 10:58 pm  

Is it possible to buy some encoder(button push and turn)because the first one of my spectralis 1 don't work when I push it or is it possible to clean it?


ReplyQuote
Jorg Schaaf
Member Admin
Joined:1 year  ago
Posts: 28
08/06/2018 11:05 pm  

The encoder cap probably is just sticking at a low position since transportation. Just remove the cap and check the encoder button without the cap. If it works then, just put the cap onto it again. I am sure, it will come to work then again. If you look from the side you can see, that a cap with a too low position is pushing against the encoder shaft. So the movement can not trigger the button anymore. 


ReplyQuote
toh
 toh
Active Member
Joined:3 months  ago
Posts: 8
09/06/2018 4:28 pm  

You are right! Thanks a lot, I was not even reported to me that its movement was shorter. The cap don't stay anymore in hight position so I put a little paper inside (for the moment) and it works very well now.:)


Jorg Schaaf liked
ReplyQuote
Jorg Schaaf
Member Admin
Joined:1 year  ago
Posts: 28
10/06/2018 3:52 am  

Thanks for your feedback! Glad to hear, that it solved your problem!


toh liked
ReplyQuote