RT-311 Audio demos

1.) First RT-311 demo

      RT-311RT-451_demo

I created that demo with an early prototype of the swarm oscillator. I created a lot of different sounds together with our RT-451 filter, envelopes and VCAs from Doepfer etc.

2.) RT-311 Sync Experiments

      SyncSwarm

In this demo you are listening to some live tweaking of an oscillator synchronisation patch. I fed the oscillator into the FXs of my mixing desk to create these sonic landscapes.

3.) Musical Scales

      Swarmscale_withoutSwarm

In this example I am experimenting with the scale settings of the RT-311 swarm oscillator. The „swarm“ itself is not in use in this example – I am using the oscillators like two single oscillators. The LFO, that controls the pitch input, controls the cutoff frequency of the RT-451 multimode filter in the sawtooth section of this demo (starts at the half of the file). Setting the modulation depth of both filters in opposite direction creates this stereo animation. At the end I am deactivating the scale quantizer so you can hear, what the oscillator would sound like without the quantizer. I am using the tape delay setting of the soundcraft mtk mixer and feed the echo signal into the reverb fx of the second fx processor.

4.) Swarm Chords 2

      Chords_2

The oscillator swarm offers some chord presets, that can be used as tuning sets for the swarm. I fed the oscillator into the RT-451 dual multimode filter. The cutoff frequency is under control of an ADSR envelope. Finally I put a little delay onto the demo.

5.) Swarm Chords

      SwarmChords

The oscillator swarm offers some chord presets, that can be used as tuning sets for the swarm. I fed the oscillator into the RT-451 dual multimode filter. The cutoff frequency is under control of an ADSR envelope. Finally I put a little delay onto the demo. You can listen to three different short clips.

6.) Interpolating Sequence

      InterpolaterSequenz

In this example you are listening to the RT-311 Swarm Oscillator interpolating patch, triggered by a one bar beatstep sequence. The interpolator is controlled by the RT-311 internal LFO. The external cv output of the interpolator controls the RT-451 for additional filter effects. After some dry bars I added some reverb and delay for a more cosmic experience

7.) Interpolating Swarm Chords

      InterpolatorClouds

The parameters of the RT-311 can be automated by interpolating between different snapshots of sound settings. There is even an interpolator data output for the control of additional modules. In this example the RT-451 Dual Filter module is connected to this output.You are listening to waveform, pitch and TLM modulation, FM etc. changing continuously over time and you probably have never heard before that all these parameters are changing simultaneously.

back to RT-311 product page…